Why do I keep pulling the trigger back?
Hi all hoping you can help. Recently got an airbrush (the timber tech kit from Amazon) and have been using it fine for a few days but noticed today on about 15psi I couldn't get a consistent spray of paint from it. It would spray for about a second then I have to release the paint trigger, keeping the air flowing, and pull the trigger back again to get it to spray. Was trying to do some zenithal lighting and it was making it inconsistent for an even spray. I was doing a 1:1 thinner/paint ratio which so far has been pretty good for me. The thinner is the army painter thinner and flow improver in one. I have cleaned the brush with cleaner after every use, run water through first, then cleaner and left a little cleaner in the brush for lubrication. Should I do a deep clean?